Mould Heaters

Below is listed key features of this equipment with links to specifications. Note that links to pdfs will open in a new window.

Mould Heaters

Product Overview

Turbogel and Thermogel units are temperature controllers particularly suitable for the conditioning of moulds and cylinders in the application fields of die-casting, plastic and rubber, guaranteeing high product precision and quality, maximum repeatability and process efficiency, minimum running costs, simple and safe use.

Control Panel

With an interface that is easy and simple to use, the display shows the temperature level in big type and there is a wide alphanumeric operating screen.

Microprocessor

Monitoring of several parameters (operating pressure and temperature). Temperature control with the precision of +0.3°C. The temperature variation is tune-up following a proportional-integral logic. Permanent digital read-out of the process water temperature and pressure.

Control and Electrical Circuit

Electrical panel EN60204/1 IP 55 certified with shut-off switch. Procedures are completely automatic for loading and unloading mould circuit. Acoustic alarm, pre-arranged optic alarm which can also be remote installed.

Interfaceability

Serial protocol for production machines of the most famous trademarks. Signal re-transmission and remote-set analogue signals.

Hydraulic Circuit

High Performance stainless steel pumps, with special seal and tropicalized motor (up to +60°C). Pressure adjustment by-pass device. Manual or automatic loading. A kit for the automatic draining of the unit circuit is available. The internal hydraulic circuit consists of 100% of stainless materials, ensuring maximum life.

Frame

Made of steel painted with epoxy powder, removable panels, installation on rotating wheels.